Auto-reconnect in 30 minutes after out-of-range disconnection
Ability to disconnect via a rising edge on PC2
Working status signal on PB2: low – not working, high – working
Paired-up status indicator on PIO 10(a red LED) and PIO 11(a blue LED):
Paired: red and blue blinks 1 time/2s in interval
Unpaired: blue blinks 2 times/sec
Default pincode: 0000
Typical -80dBm sensitivity
+4dBm RF transmit power
Fully qualified Bluetooth V2.0+EDR 3Mbps Modulation
Operating voltage: 3.3v
Built-in antenna
Features
Features
Save that extra Arduino you have lying around for another project, this two-for-one device has the Arduino built-in. Bluetooth Bee with Arduino is an enhanced version of the Bluetooth Bee. We added an onboard ATMEGA168 to it to make it a full-featured Arduino while maintaining the same footprint and instruction set as the Bluetooth Bee. Plus, it still allows you to stack it on XBee Carrier, XBee® Shield, and UartSBee for expansion or reprogramming
